![]() Press the select button to initialise the system.You should now be ready to use the system! The images show the stages of operation. the actual cost of the electronics is only £22 so there is probably room for a lot of optimisation here. Most of the cost here is for cases, nuts and bolts, etc. Total cost was around £55, this assumes access to both a laser cutter and 3D printer. 4 x 3D printed enclosures - Material cost was around £5.Plastic PCD standoffs - Kits of these can be had for quite cheap on Ebay.- £6.80.4x 1/4 inch nut - To fit a standard tripod thread - £2.Make sure the power of the laser is not greater than 5mW. 2 x Laser module - Searching ebay for "arduino laser" should show plenty of options. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |